UU-F-1206 Folder, FileThis specification covers file folders for use in drawer and shelf files. Measurements provided herein are in the U.S. customary system i.e. inches & pounds. Offerors are encouraged to provide metric equivalent products. To facilitate the use of metric equivalent products, see Table VIII. For acceptance purposes, U.S. customary units take precedence.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26

UU-F-1206C

4.1 Responsibility for Inspection. Unless otherwise specified in the contract or purchase order, the supplier is responsible for performance of all inspection requirements as specified herein. Except as otherwise specified the supplier may utilize his own facilities or any commercial laboratory acceptable to the Government. The Government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure that supplies and services conform to prescribed requirements.

4.1.1 Sampling for Inspection. Sampling for inspection shall be performed in accordance with the provisions set forth in MIL-STD-105, except where otherwise indicated.

4.2 Component Testing. Each lot of paperboard, and each lot of fasteners, and each lot of cloth gusset material, used in the manufacture of file folders shall be tested for the characteristics and in accordance with the referenced test methods in Table III.

4.2.1 Paperboard. The lot size shall be expressed in pounds of paperboard manufactured by one source of supply at, essentially, the same time and conditions. Sample using level S-1, AQL 2.5% defective. The sample unit shall include all values upon which the results are based. Test results must be traceable to end item (file folders) lots. All paperboard samples shall be conditioned according to TAPPI T 402, before testing.

4.2.2 Fasteners. The lot size shall be expressed in bundles of 1,000 fasteners manufactured by one source of supply at essentially, the same time and conditions. Sample using level S-1, AQL 2.5% defective. The sample unit shall consist of 1 fastener for each test. Test results shall include all values upon which the results are based. Test results must be traceable to end item (file folder) lots.

4.2.3 Gussets, Cloth (If Applicable) The lot size shall be expressed in bolts of rolls of cloth manufactured by one source of supply at essentially, the same time and conditions. Sample using inspection level S-1

AQL 2.5% defective. The sample unit shall consist of 1 swatch of cloth for the test. Test results shall include all values upon which the results are based. Test results must be traceable to end item (file folder) lots.

4.3 Inspection of end item.

14                                                                         FSC 7530